3.4.2 This is how you restore data from the service system
Proceed as follows
To restore the complete system:
1. Connect the service system to a USB interface (X125 or X135) of the NCU and press the
reset button.
Alternatively, you can switch the NCU off, connect the service system, and switch the NCU
on again.
Result: The NCU boots from the service system and the main menu is displayed.
2. In the main menu, select the menu item "Service Shell".
3. Log on as a service technician using the user name "manufact" and password "SUNRISE".
4. With the command "sc restore" you can write the backup file "backup01" from the service
system back to the CompactFlash Card in the NCU. The complete path should be specified.
Example: sc restore /data/backup01.tgz
Result:
The system state stored in the file "backup01" is restored on the NCU.
Note
If access to the system data on the CompactFlash Card is not possible because the
CompactFlash Card is defective or empty, you can only log in as user "admin" with the
password "SUNRISE" and no longer as the user "manufact".
3.4.3 This is how you save data on a network drive
Sequence
Proceed as follows:
● Connect the service system.
● "Service Shell" open.
● Establish a connection to a network drive.
● Create a backup file.
Scenario I: Start Command Shell under Linux
Procedure:
1. Connect the service system to the USB interface X125 or X135 of the NCU.
2. In the main menu, select the menu item "Service Shell".
3. Log on as a service technician using the user name "manufact" and password "SUNRISE".
Service and diagnostics
3.4 Backing up data via the service shell
NCU operating system
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 81
To Next Page
Loading...
Need help?
General
