Siemens SINUMERIK ONE MCP 2400.4c Commissioning Manual

Reading the 4th line of a file:
Requirement/assumption:
Content of c:/tmp/myfile.mpf:
R[0]=0
F3500 G1
MYLOOPIDX1: X0 y-50 Z0
X150 Y50 Z10
R[0]=R[0]+1
GOTOB MYLOOPIDX1
M30
MyVar = RDLINEFILE("C:/tmp/myfile.mpf", 4)
Result:
MyVar now contains the value " R[0]=R[0]+1"
Writing at the end of a file:
Requirement/assumption:
VARX=123
VARY=456
WRLINEFILE("F100 X" << VARX << " Y" << VARY, "C:/tmp/mypp.mpf")
Result:
Content of c:/tmp/mypp.mpf:
<…>
F100 X123 Y456
6.3.12 Dialog line (DLGL)
Description
It is possible to configure short texts (messages or input tips) for output in the dialog line of the
dialog in response to certain situations.
Possible number of characters in the default font size: approx. 50
Programming commands
6.3 Functions
SINUMERIK Integrate Run MyScreens (BE2)
150 Programming Manual, 12/2017, 6FC5397-1DP40-6BA1

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English