EasyManuals Logo
Home>Siemens>Control Systems>SINUMERIK ONE MCP 2400.4c

Siemens SINUMERIK ONE MCP 2400.4c Commissioning Manual

Siemens SINUMERIK ONE MCP 2400.4c
1734 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1555 background imageLoading...
Page #1555 background image
PCU-Basesoftware (IM8)
Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
135
List of Abbreviations
A
A.1
Abbreviations
CF
CompactFlash card: Memory card
CFS
Cluster File System
DCK
Direct Control Keys: Direct control keys
DCP
Discovery and Basic Configuration Protocol
DHCP Dynamic Host Configuration Protocol: Dynamic assignment of an IP address and other configuration
parameters on a computer in a network
DNS
Domain Name System: Conversion of domain names into IP addresses
EBS
Emergency Boot System
EKS
Electronic Key System: System to check the identity of a user (authentication system)
EUNA
End User Notification Administration
HMI
Human Machine Interface: Operator interface
IRT
Isochronous Realtime (Ethernet)
LLDP Link Layer Discovery Protocol: multi-vendor Layer 2 Protocol defined in accordance with the IEEE-
802.1AB standard, allows information to be exchanged between devices.
MAC
Media Access Control: The MAC address is a 48-bit Ethernet ID.
MCP
Machine Control Panel: Machine control panel
MPI
Multi-Point Interface: Multiple interface
MUI
Multilanguage User Interface
NCK Numerical Control Kernel: NC kernel with block preparation, travel range, etc.
NCU
Numerical Control Unit: NCK hardware unit
NRT Non-Realtime (Ethernet)
NTFS
New Technology File System
NTP
Network Time Protocol: Standard for synchronizing clocks in the entire network
NTPD NTP Daemon:
Utility that runs in the background and does not have to be started by the user.
PCU
PC Unit: Computer unit
PDEV
Physical device
PG
Programming device
PLC
Programmable Logic Control: Programmable logic controller
RAM
Random Access Memory: Program memory which can be read and written into
RDY
Ready: The system is ready to operate.
SNMP Simple Network Management Protocol (network protocol for monitoring and controlling network elements
such as routers, servers, switches, and printers from a central station).
SSD
Solid State Drive
TCU
Thin Client Unit
TFTP Trivial File Transfer Protocol: Very simple data transmission protocol
UDP
User Datagram Protocol: NTP is mostly processed via UDP.

Table of Contents

Other manuals for Siemens SINUMERIK ONE MCP 2400.4c

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK ONE MCP 2400.4c and is the answer not in the manual?

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK ONE MCP 2400.4c
CategoryControl Systems
LanguageEnglish

Related product manuals