Siemens SINUMERIK ONE MCP 2400.4c Commissioning Manual

Identifier Parameter or property System variable
*)
SupWarningTime Tool life warning limit $TC_MOP1
SupRemainingTime Tool life actual value $TC_MOP2
SupWarningPieces Prewarning limit for workpiece count $TC_MOP3
SupRemainingPieces Actual value for workpiece count $TC_MOP4
SupDesiredTime Setpoint for tool life $TC_MOP11
SupDesiredPieces Setpoint for workpiece count $TC_MOP13
SupWarningWear Prewarning limit for wear $TC_MOP5
SupRemainingWear Actual value for wear $TC_MOP6
SupDesiredWear Setpoint for wear $TC_MOP15
SupExtendedAlarm PLC tool management: Extended alarm -
SupWarningPiecesIncre‐
mental
PLC tool management: Prewarning limit for work‐
piece count
$TC_MOP13 -
$TC_MOP3
SupActualPieces PLC tool management: Actual value for workpiece
count
$TC_MOP13 -
$TC_MOP4
EdgeSupUser_1, ...
EdgeSupUser_10
OEM cutting edge monitoring parameters 1 to 10 $TC_MOPC1, ...
$TC_MOPC10
EdgeSupAppl_1, ... Edge‐
SupAppl_10
Siemens application cutting edge monitoring pa‐
rameters 1 to 10
$TC_MOPCS1, ...
$TC_MOPCS10
*)
Parameter corresponds to the system variable or the system variable is the basis for this parameter.
12.2.2.4 Grinding parameter identifiers
For grinding parameters, the following identifiers are used in the configuration file:
Identifier/parameter Meaning System variable
*)
GrindingSpindleNo Spindle number $TC_TPG1
GrindingConnectionRule Chaining rule $TC_TPG2
MinimalDiscRadius Minimum grinding wheel radius $TC_TPG3
ActualDiscRadius Actual grinding wheel radius (read ac‐
cess only)
-
MinimalDiscWidth Minimum grinding wheel width $TC_TPG4
ActualDiscWidth Actual grinding wheel width $TC_TPG5
MaximalDiscSpeed Maximum grinding wheel speed $TC_TPG6
MaximalDiscPeripheralVelocity Maximum grinding wheel peripheral ve‐
locity
$TC_TPG7
AngleBevelDisc Angle of inclined wheel $TC_TPG8
ParamForRadiusCalculation Parameters to calculate the radius $TC_TPG9
DressingPath Directory path to the dressing program $TC_TPG_DRSPATH
DressingProgram Dressing program name $TC_TPG_DRSPROG
*)
Parameter corresponds to the system variable or the system variable is the basis for this parameter.
Tool management
12.2 Configuring the user interface
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 187

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English