4. Use the command "sc connect" to connect the network drive:
sc connect //username%password@server/share /tmp/backup
Please enter here the user name and the password for the network drive that is to be
connected to.
5. Using the command "sc save", create the backup file "backup01".
Choose –full, to backup all data on the CompactFlash Card, or –user, if you only want to
backup user data in the directory /user.
Example: sc save –full /tmp/backup/backup01
Result:
A backup file of the complete CompactFlash Card is created under the specified path on
the network drive.
Scenario II: Start the command shell with WinSCP on the programming device:
Procedure:
1. Start WinSCP and enter the following data in the log-on window:
– IP address of the NCU (or, if required, host name)
– User name "manufact" with password "SUNRISE".
2. Select in the menu "Commands" → "Open Terminal".
3. Execute the data backup using the commands described in steps 4 to 6 from scenario I.
Scenario II: Start the command shell using the VNC Viewer on the programming device
Procedure:
1. Start the VNC Viewer and connect to the NCU using the IP address (or where relevant,
using the host name)
2. Log on under the "manufact" user name with the password "SUNRISE".
3. To restore the data, enter the corresponding commands as described under steps 3 to 5
in scenario I.
3.4.4 This is how you restore data from the network drive
Sequence
Proceed as follows:
● Connect the service system.
● "Service Shell" open.
● Establish a connection to a network drive.
● Restore the data.
Service and diagnostics
3.4 Backing up data via the service shell
NCU operating system
82 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
