Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-57
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show dpvm
show dpvm
To display dynamic port VSAN membership (DPVM) information, use the show dpvm command.
show dpvm {database [active] | pending | pending-diff | ports [vsan vsan-id] | status}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines To use this command, DPVM must be enabled using the dpvm enable command.
Examples The following example shows how to display DPVM database information.
switch# show dpvm database
pwwn 00:00:00:00:00:00:00:01 vsan 1
pwwn 00:00:00:00:00:00:00:02 vsan 1
[Total 2 entries]
Related Commands
database Displays both the configured and active DPVM databases.
active Displays only the active DPVM database.
pending Displays pending DPVM operations.
pending-diff Displays differences between the pending DPVM operations and the active
DPVM database.
ports Displays DPVM information for the ports.
vsan vsan-id Specifies a VSAN ID. The range is from 0 to 4093.
status Displays DPVM status information.
Release Modification
2.0(x) This command was introduced.
Command Description
dpvm database Configures the DPVM database.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English