Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
14-14
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 14 L Commands
logging console
logging console
To set console logging, use the logging console command. To negate the previously issued command or
to revert to factory defaults, use the no form of the command.
logging console [severity-level]
no logging console [severity-level]
Syntax Description
Defaults Disabled.
The default severity level is 2.
Command Modes Configuration mode.
Command History
Usage Guidelines The switch logs messages at or above the configured severity level.
Examples The following example reverts console logging to the factory set default severity level of 2 (critical).
Logging messages with a severity level of 2 or above will be displayed on the console.
switch# config terminal
switch(config)# logging console 2
Related Commands
severity-level Specifies the maximum severity of messages logged. The range is 0 to 7,
where 0 is emergency, 1 is alert, 2 is critical, 3 is error, 4 is warning, 5 is
notify, 6 is informational, and 7 is debugging.
Release Modification
1.0(2) This command was introduced.
Command Description
show logging Displays logging configuration information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English