Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-147
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ips ipv6
show ips ipv6
To display an IPv6 storage routing table, use the show ips ipv6 command.
show ips ipv6 {neighbors interface gigabitethernet slot/port |
prefix-list interface gigabitethernet slot/port |
route interface gigabitethernet slot/port |
routers interface gigabitethernet slot/port |
traffic interface gigabitethernet slot/port}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines You can use the show ips ipv6 command to display information about IPv6 routing.
Examples The following example displays IPv6 neighbors information.
switch# show ips ipv6 neighbours interface gigabitethernet 1/1
IPv6 Address Age (min) Link-layer Addr State Inter
face
fe80::206:d6ff:fe23:4008 0 0006.d623.4008 S
GigabitEthernet1/1
The following example displays the IPv6 prefix-list information.
switch# show ips ipv6 prefix-list interface gigabitethernet 1/1
Prefix Prefix-len Addr
Valid Preferred
2000:: 64 2000::205:30ff:fe01:a6be
1000 1000
neighbors Displays the IPv6 neighbors table.
interface Displays the interface status and configuration.
gigabitethernet Displays a Gigabit Ethernet interface.
slot/port Specifies the slot and port number.
prefix-list Displays theIPv6 prefix-list table.
route Displays the IPv6 route table.
routers Displays the IPv6 routers table.
traffic Displays the IPv6 traffic table.
Release Modification
3.1(0) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English