Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
27-3
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zone clone
zone clone
To clone a zone name, use the zone clone command in configuration mode.
zone clone origZone-Name cloneZone-Name vsan vsan-id
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines Use the no form of the zone name (configuration mode) command to delete the zone name.
Examples The following example creates a clone of the original zone group named origZone into the clone zone
group cloneZone on VSAN 45.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# zone clone origZone cloneZone vsan 45
Related Commands
origZone-Name
cloneZone-Name
Clones a zone attribute group from the current name to a new name.
Maximum length of names is 64 characters.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
2.1(1a) This command was introduced.
Command Description
show zone Displays zone information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English