Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
20-27
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
rmon event
rmon event
To configure a remote monitoring (RMON) event, use the rmon event command in configuration mode.
To delete an RMON event, use the no form of the command.
rmon event event-number [description text [owner owner-name] | log [trap trap-name]
[description text] [owner owner-name] | owner owner-name | trap community-string
[description text] [owner owner-name]]
no rmon event event-number
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines The events created by this command can be triggered by alarms configured using the rmon alarm
command.
Examples The following example configures an RMON event.
switch# config terminal
switch(config)# rmon event 2 log trap eventtrap description CriticalErrors owner Test2
Related Commands
event-number Specifies the RMON event number. The range is 1 to 65535.
description text Specifies a description of the event. Maximum length is 80 characters.
owner owner-name Specifies an owner for the alarm. Maximum length is 80 characters
log Generates an RMON log entry when the event is triggered by an alarm.
trap community-string Generates an SNMP notification when event is triggered by an alarm.
Maximum length is 32 characters.
Release Modification
2.0(x) This command was introduced.
Command Description
rmon alarm Configures an RMON alarm.
show rmon Displays RMON configuration information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English