Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
2-9
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 2 A Commands
aaa group server
aaa group server
To configure one or more independent server groups, use the aaa group server command in
configuration mode. To remove the server group, use the no form of this command to remove the server
group.
aaa group server {radius | tacacs+} group-name
server server-name
no server server-name
no aaa group server {radius | tacacs+} group-name
Syntax Description
Defaults None.
Command Modes Configuration.
Command History
Usage Guidelines You can configure these server groups at any time but they only take effect when you apply them to a
AAA service using the aaa authentication login or the aaa accounting commands.
Examples You can configure these server groups at any time but they only take effect when you apply them to a
AAA service using the aaa authentication or the aaa accounting commands.
switch# config terminal
switch(config)# aaa group server tacacs+ TacacsServer1
switch(config-tacacs+)# server ServerA
switch(config-tacacs+)# exit
switch(config)# aaa group server radius RadiusServer19
switch(config-radius)# server ServerB
switch(config-radius)# no server ServerZ
radius Specifies the RADIUS server group.
tacacs+ Specifies the TACACS+ server group.
group-name Identifies the specified group of servers with a user-defined name. The name
is limited to 64 alphanumeric characters.
server server-name Specifies the server name to add or remove from the server group.
Release Modification
1.3(1) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English