Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-64
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug ipconf
debug ipconf
To enable IP configuration debugging, use the debug ipconf command in EXEC mode. To disable a
debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
debug ipconf {all | errors | events | info | pss}
no debug ipconf {all | errors | events | info | pss}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug ipconf all command is issued:
switch# debug ipconf all
switch# 2005 Mar 10 02:45:30 ipconf: Received MTS message
2005 Mar 10 02:45:30 ipconf: MTS message received opcode 862 source 0x00000601/27
2005 Mar 10 02:45:30 ipconf: Getting ip addresses on interface 5000000
2005 Mar 10 02:45:30 ipconf: Received MTS message
2005 Mar 10 02:45:30 ipconf: MTS message received opcode 862 source 0x00000601/27
2005 Mar 10 02:45:30 ipconf: Getting ip addresses on interface 5000000
2005 Mar 10 02:45:30 ipconf: Received MTS message
2005 Mar 10 02:45:30 ipconf: MTS message received opcode 862 source 0x00000601/27
2005 Mar 10 02:45:30 ipconf: Getting ip addresses on interface 5000000
Related Commands
all Enables debugging for all IP configuration features.
errors Enables debugging for IP configuration error conditions.
events Enables debugging for IP configuration tx/rx MTS events.
info Enables debugging for IP configuration information.
pss Enables debugging for IP configuration PSS operations.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English