Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-4
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug all
debug all
To enable debugging for all features on the switch, use the debug all command in EXEC mode. To
disable this command and turn off all debugging, use the no form of the command.
debug all
no debug all
Syntax Description This command has no arguments or keywords.
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines The no debug all command turns off all diagnostic output. Using the no debug all command is a
convenient way to ensure that you have not accidentally left any debug commands turned on.
Caution Because debugging output takes priority over other network traffic, and because the debug all command
generates more output than any other debug command, it can severely diminish the performance of the
switch or even render it unusable. In virtually all cases, it is best to use more specific debug commands.
Examples The following example displays the system output when the debug all command is issued:
switch# debug all
Related Commands
Release Modification
1.0(2) This command was introduced.
Command Description
show debug Displays the debug commands configured on the switch.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English