Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-87
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
iscsi initiator idle-timeout
iscsi initiator idle-timeout
To configure the iSCSI initiator idle timeout, use the iscsi initiator idle-timeout command. To revert to
the default, use the no form of the command.
iscsi initiator idle-timeout seconds
no iscsi initiator idle-timeout seconds
Syntax Description
Defaults 300 seconds.
Command Modes Configuration mode.
Command History
Usage Guidelines When the idle timeout value is set to 0, the initiator information is cleared immediately after the last
session from the initiator terminates.
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following example configures the iSCSI initiator idle timeout to 180 seconds.
switch# config terminal
switch(config)# iscsi initiator idle-timeout 180
The following example reverts the default value of 300 seconds.
switch# config terminal
switch(config)# no iscsi initiator idle-timeout 240
Related Commands
seconds Specifies the timeout in seconds. The range is 0 to 3600.
Release Modification
1.3 This command was introduced.
Command Description
show iscsi global Displays global iSCSI configuration information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English