Send documentation comments to mdsfeedback-doc@cisco.com
27-12
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zone mode enhanced vsan
zone mode enhanced vsan
To enable enhanced zoning for a VSAN, use the zone mode enhanced vsan command in configuration
mode. To disable this feature, use the no form of the command.
zone mode enhanced vsan vsan-id
no zone mode enhanced vsan vsan-id
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines Before using the zone mode enhanced vsan command, verify that all switches in the fabric are capable
of working in enhanced zoning mode. If one or more switches are not capable of working in enhanced
zoning mode, then the request to enable enhanced zoning mode is rejected.
When the zone mode enhanced vsan command completes successfully, the software automatically
starts a session, distributes the zoning database using the enhanced zoning data structures, applies the
configuration changes, and sends a release change authorization (RCA) to all switches in the fabric. All
switches in the fabric then enable enhanced zoning mode.
Examples The following example shows how to enable enhanced zoning mode.
switch# config terminal
switch(config)# zone mode enhanced vsan 10
Related Commands
vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
2.0(x) This command was introduced.
Command Description
show zone Displays zone information.
To Next Page
Loading...
Need help?
General