Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
18-2
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 18 P Commands
passive-mode
passive-mode
To configure the required mode to initiate an IP connection, use the passive-mode command. To enable
passive mode for the FCIP interface, use the no form of the command.
passive-mode
no passive-mode
Syntax Description This command has no keywords or arguments.
Defaults Disabled
Command Modes Interface configuration submode.
Command History
Usage Guidelines Access this command from the
switch(config-if)# submode.
By default, the active mode is enabled to actively attempt an IP connection.
If you enable the passive mode, the switch does not initiate a TCP connection and merely waits for the
peer to connect to it.
Examples The following example enables passive mode on an FCIP interface.
switch# config terminal
switch(config)# interface fcip 1
switch(config-if)# passive-mode
Related Commands
Release Modification
1.1(1) This command was introduced.
Command Description
show interface fcip Displays an interface configuration for a specified FCIP interface.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English