Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
27-18
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zone-attribute-group clone
zone-attribute-group clone
To clone a zone attribute group, use the zone-attribute-group clone command in configuration mode.
zone attribute clone origAttGrp-Name cloneAttGrp-Name vsan vsan-id
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines To remove the zone attribute group, use the no form of the zone-attribute-group name command.
Examples The following example shows how to clone a zone attribute group with the original name
origZoneAttGrp to a copy named cloneZoneAttGrp on VSAN 45.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# zone-attribute-group clone origZoneAttGrp cloneZoneAttGrp vsan 45
Related Commands
origAttGrp-Name
cloneAttGrp-Name
Clones a zone attribute group from the current name to a new name.
Maximum length of names is 64 characters.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
2.1(1a) This command was introduced.
Command Description
show zone-attribute-group Displays zone attribute group information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English