Send documentation comments to mdsfeedback-doc@cisco.com
5-8
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 5 D Commands
delete certificate
delete certificate
To delete the identity certificate, use the delete certificate command in trust point configuration
submode.
delete certificate [force]
Syntax Description
Defaults None.
Command Modes Trust point configuration submode.
Command History
Usage Guidelines Use this command to delete the identity certificate from the trust point CA. This action may be necessary
when the identity certificate expires or the corresponding key pair is compromised. Applications will be
left without any identity certificate to use after the deletion of the last or the only identity certificate
present. Accordingly, an error message is generated if the certificate being deleted is the last or only
identity certificate present. If needed, the deletion can still be accomplished by forcing it using the force
option.
Note The trust point configuration, certificates, and key pair configurations are made persistent only after
saving to the startup configuration. To be consistent with this configuration behavior, the delete behavior
is also the same. That is, the deletions are made persistent only after saving to the startup configuration.
Use the copy running-config startup-config command to make the certificate and key pair deletions
persistent.
Examples The following example shows how to delete the identity certificate.
switch# config terminal
switch(config)# crypto ca trustpoint admin-ca
switch(config-trustpoint)# delete certificate
The following example shows how to force the deletion of the identity certificate.
switch(config-trustpoint)# delete certificate force
force Forces the deletion of the identity certificate.
Release Modification
3.0(1) This command was introduced.
To Next Page
Loading...
Need help?
General