EasyManuals Logo
Home>Cisco>Switch>MDS 9000 Series

Cisco MDS 9000 Series Command Reference

Cisco MDS 9000 Series
1464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1461 background imageLoading...
Page #1461 background image
Send documentation comments to mdsfeedback-doc@cisco.com
27-23
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zoneset (configuration mode)
zoneset (configuration mode)
To group zones under one zone set, use the zoneset command in configuration mode. To negate the
command or revert to the factory defaults, use the no form of the command.
zoneset {activate name zoneset-name vsan vsan-id |
clone zoneset-currentName zoneset-cloneName |
distribute full vsan vsan-id |
name zoneset-name vsan vsan-id |
rename current-name new-name vsan vsan-id}
no zoneset {activate name zoneset-name vsan vsan-id |
clone zoneset-currentName zoneset-cloneName |
distribute full vsan vsan-id |
name zoneset-name vsan vsan-id |
rename current-name new-name vsan vsan-id}
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines Zones are activated by activating the parent zone set.
The zoneset distribute full vsan command distributes the operational values for the default zone to all
zone sets in a VSAN. If you do not want to distribute the operation values, use the system default zone
distribute full command to distribute the default values.The default values are used when you initially
create a VSAN and it becomes active.
activate Activates a zone set
clone
zoneset-currentName
zoneset-cloneName
Clones a zone set from the current name to a new name. Maximum length
of names is 64 characters.
name zoneset-name Specifies a name for a zone set. Maximum length is 64 characters.
distribute full Enables zone set propagation.
vsan
vsan-id Activates a zone set on the specified VSAN. The range is 1 to 4093.
rename Renames a zone set.
current-name Specifies the current fcalias name.
new-name Specifies the new fcalias name.
Release Modification
1.0(2) This command was introduced.
2.0(x) Added the rename option.
2.1(1a) Added the clone option.

Table of Contents

Other manuals for Cisco MDS 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MDS 9000 Series and is the answer not in the manual?

Cisco MDS 9000 Series Specifications

General IconGeneral
BrandCisco
ModelMDS 9000 Series
CategorySwitch
LanguageEnglish

Related product manuals