Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
23-34
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 23 T Commands
tcp qos
tcp qos
To specify the differentiated services code point (DSCP) value to mark all IP packets (type of
service—TOS field in the IP header) on an ISCSI interface, use the tcp qos command. Use the no form
of this command to disable this feature or revert to its factory defaults.
tcp qos value
no tcp qos value
Syntax Description
Defaults 0
Command Modes FCIP profile configuration submode.
Command History
Usage Guidelines Use these TCP parameters to control TCP retransmission behavior in a switch.
Examples The following example configures the TCP QoS value on an iSCSI interface.
switch# config terminal
switch(config)# interface iscsi 1/2
switch(config-if)# tcp qos 5
Related Commands
value Applies the control DSCP value to all outgoing frames in the control
TCP connection.
Release Modification
1.1(1) This command was introduced.
Command Description
fcip profile Configures FCIP profile parameters.
show fcip profile Displays FCIP profile information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English