Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-30
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
snmp port
snmp port
Use the snmp port command to enable SNMP control of FICON configurations. To disable the
configuration or to revert to factory defaults, use the no form of the command.
snmp port control
no snmp port control
Syntax Description This command has no arguments or keywords.
Defaults SNMP control of FICON configurations is enabled.
Command Modes FICON configuration submode.
Command History
Usage Guidelines By default, SNMP users can configure FICON parameters through the Fabric Manager application. You
can prohibit this access, if required, by issuing the no snmp port control command.
Examples The following example prohibits SNMP users from configuring FICON parameters.
switch(config)# ficon vsan 2
switch(config-ficon)# no snmp port control
The following example allows SNMP users to configure FICON parameters (default).
switch(config-ficon)# snmp port control
Related Commands
Release Modification
1.3(1) This command was introduced.
Command Description
show ficon Displays configured FICON details.
ficon vsan vsan-id Enables FICON on the specified VSAN.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English