Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
14-18
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 14 L Commands
logging module
logging module
To set message logging for linecards, use the logging module command. To negate the previously issued
command or to revert to factory defaults, use the no form of the command.
logging module [severity-level]
no logging module [severity-level]
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example sets message logging for modules at level 7.
switch## config terminal
switch(config)# logging module 7
Related Commands
severity-level Specifies the maximum severity of messages logged. The range is 0 to 7,
where 0 is emergency, 1 is alert, 2 is critical, 3 is error, 4 is warning, 5 is
notify, 6 is informational, and 7 is debugging.
Release Modification
1.0(2) This command was introduced.
Command Description
show logging Displays logging configuration information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English