Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-103
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug san-ext-tuner
debug san-ext-tuner
To enable debugging for SAN extension tuner, use the debug san-ext-tuner command in EXEC mode.
To disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
debug isns {all | demux | deque | error | event | ha | trace [detail] | warning}
no debug isns {all | bypass ficon_mgr | demux | deque | error | event | ha | trace [detail] |
warning}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug san-ext-tuner error command is
issued.
switch# debug san-ext-tuner error
all Enables all SAN extension tuner debugging.
demux Enables debugging for SAN extension tuner message demux.
deque Enables debugging for SAN extension tuner message dequeue.
error Enables debugging for SAN extension tuner error conditions.
event Enables debugging for SAN extension tuner events.
ha Enables debugging for SAN extension tuner high availability.
trace Enables debugging for SAN extension tuner trace.
detail Enables detailed debugging for SAN extension tuner trace.
warning Enables debugging for SAN extension tuner warnings.
Release Modification
2.0(x) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English