Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-95
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug qos
debug qos
To enable debugging for quality of service (QoS), use the debug qos command in EXEC mode. To
disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
debug qos {all [interface fc slot/port] | detail | errors supervisor | flow | trace}
no debug qos {all [interface fc slot/port] | detail | errors supervisor | flow | trace}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug qos all command is issued:
switch# debug qos all
Related Commands
all Enables all QoS debug options.
interface fc slot/port Restricts debugging to the specified interface.
detail Enables all QoS debug output.
errors supervisor Enables debugging for supervisor QoS error conditions.
flow Enables flow-level QoS debug options.
trace Enables debugging for QoS traces.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.
show qos Displays the current QoS settings along with a the number of frames marked
high priority.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English