Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-33
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
clear crypto ike domain ipsec sa
clear crypto ike domain ipsec sa
To clear the IKE tunnels for IPsec, use the clear crypto ike domain ipsec sa command.
clear crypto ike domain ipsec sa [tunnel-id]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command.
If the tunnel ID is not specified, all IKE tunnels are cleared.
Examples The following example shows how to clear all IKE tunnels.
switch# clear crypto ike domain ipsec sa
Related Commands
tunnel-id Specifies a tunnel ID. The range is 1 to 2147483647.
Release Modification
2.0(x) This command was introduced.
Command Description
crypto ike domain ipsec Configures IKE information.
crypto ike enable Enables the IKE protocol.
show crypto ike domain
ipsec
Displays IKE information for the IPsec domain.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English