Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-72
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
clear santap module
clear santap module
To clear SANTap information, use the clear santap module command.
clear santap module slot-number {avt avt-pwwn [lun avt-lun] |
itl target-pwwn host-pwwn |
session session-id}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example shows how to remove a SANTap session.
switch# clear santap module 13 session 2020
Related Commands
slot-number Specifies the Storage Services Module (SSM) module number. The range is
1 through 13.
avt avt-pwwn Removes the appliance virtual target (AVT) pWWN. The format is
hh:hh:hh:hh:hh:hh:hh:hh.
lun avt-lun Removes the appliance virtual target (AVT) LUN. The format is
0xhhhh[:hhhh[:hhhh[:hhhh]]].
itl target-pwwn
host-pwwn
Removes the SANTap Initiator Target LUN (ITL) triplet. The format of the
target-pwwn and the host-pwwn is hh:hh:hh:hh:hh:hh:hh:hh.
session session-id Removes a session. The range for session ID is 0 through 2147483647
Release Modification
3.0(1) This command was introduced.
Command Description
santap module Configures the mapping between the Storage Services Module (SSM) and
the VSAN where the appliance is configured.
show santap module Displays the configuration and statistics of the SANTap feature.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English