Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
10-5
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 10 H Commands
hw-module logging onboard
hw-module logging onboard
To configure on-board failure logging (OBFL), use the hw-module logging onboard command. To
disable this feature, use the no form of the command.
hw-module logging onboard [module slot] [log-type]
no hw-module logging onboard [module slot] [log-type]
Syntax Description
Defaults Enabled.
Command Modes Configuration mode.
Command History
Usage Guidelines OBFL data uses the module’s persistent logging facility to store data in its CompactFlash memory. When
OBFL is disabled, the persistent logging facility discards all entries sent to it for logging.
Examples The following example configures on-board failure logging of memory leak events on module 2.
switch# config terminal
switch(config)# hw-module logging onboard module 2 mem-leak
Related Commands
module slot Configures OBFL for a specified module.
log-type Specifies the type of events for on-board failure logging.
cpu-hog Specifies cpu hog events.
environmental-history Specifies environmental history events.
error-stats Specifies error statistics events.
interrupt-stats Specifies interrupt statistics events.
mem-leak Specifies memory leak events.
miscellaneous-error Specifies miscellaneous information events.
obfl-log Specifies boot uptime, device version, and OBFL history.
Release Modification
3.0(1) This command was introduced.
Command Description
clear logging onboard Clears OBFL information.
show logging onboard Displays OBFL information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English