Send documentation comments to mdsfeedback-doc@cisco.com
8-60
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
ficon logical-port assign port-numbers
ficon logical-port assign port-numbers
To reserve FICON port numbers for logical interfaces on the switch, use the ficon logical-port assign
port-numbers command in configuration mode. To release the port numbers, use the no form of the
command.
ficon logical-port assign port-numbers [port-numbers]
no ficon logical-port assign port-numbers [port-numbers]
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines You must reserve port numbers for logical interfaces, such as FCIP and PortChannels, if you plan to use
them.
You cannot change or release port numbers for interfaces that are active. You must disable the interfaces
using the shutdown command.
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following example reserves port numbers 230 through 249 for FCIP and PortChannel interfaces.
switch(config)# ficon logical-port assign port-numbers 230-249
The following example reserves port numbers 0xe6 through 0xf9 for FCIP and PortChannel interfaces.
switch(config)# ficon logical-port assign port-numbers 0xe6-0xf9
The following example releases the port numbers.
switch(config)# no ficon logical-port assign port-numbers 230-249
Related Commands
port-numbers Specifies the range of port numbers to assign. The range can be 0 through
153 or 0x0 through 0x99.
Release Modification
3.0(1) This command was introduced.
Command Description
show ficon Displays configured FICON details.
To Next Page
Loading...
Need help?
General