Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
8-61
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
ficon port default-state prohibit-all
ficon port default-state prohibit-all
To set the FICON port default state to prohibit all, use the ficon port default-state prohibit-all
command in configuration mode. To disable the feature or to revert to factory defaults, use the no form
of the command.
ficon port default-state prohibit-all
no ficon port default-state prohibit-all
Syntax Description This command has no arguments or keywords.
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines You can change the default port prohibiting state to enabled in VSANs that you create and then
selectively disable port prohibiting on implmeneted ports, if desired. Only the FICON configuration files
created after you change the default have the new default setting.
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following example enables port prohibiting as the default for all implemented interfaces on the
switch.
switch(config)# ficon port default-state prohibit-all
The following example disables port prohibiting as the default for all implemented interfaces on the
switch.
switch(config)# no port default-state prohibit-all
Related Commands
Release Modification
3.0(2) This command was introduced.
Command Description
show ficon port
default-state
Displays default FICON port prohibit state.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English