Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
20-38
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
rscn distribute
rscn distribute
To enable distribution of a Registered State Change Notification (RSCN) configuration, use the rscn
distribute command in configuration mode. To disable the distribution, use the no form of the command.
rscn distribute
no rscn distribute
Syntax Description This command has no arguments or keywords.
Defaults RSCN timer distribution is disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines The RSCN timer configuration must be the same on all switches in the VSAN; otherwise, the link will
not come up. Cisco Fabric Service (CFS) automatically distributes the RSCN timer configuration to all
switches in a fabric. Only the RSCN timer configuration distributed.
Note For the CFS distribution to operate correctly for the RSCN timer configuration, all switches in the fabric
must be running Cisco SAN-OS Release 3.0(1) or later.
Examples The following example enables the distribution of an RSCN configuration.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# rscn distribute
Related Commands
Release Modification
3.0(1) This command was introduced.
Command Description
rscn abort vsan Cancels a pending RSCN configuration on a specified VSAN.
rscn commit vsan Applies a pending RSCN configuration.
rscn event-tov Configures an RSCN event timeout.
clear rscn session vsan Clears the RSCN session for a specified VSAN.
show rscn Displays RSCN configuration information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English