Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
8-50
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fcsp timeout
fcsp timeout
To configure the timeout value for FC-SP message, use the fcsp timeout command in configuration
mode. Use the no form of the command to revert to factory defaults.
fcsp timeout timeout-period
no fcsp timeout timeout-period
Syntax Description
Defaults 30 seconds
Command Modes Configuration mode.
Command History
Usage Guidelines You can only see the fcsp timeout command if you issue the fcsp enable command.
Examples The following example configures the FCSP timeout value.
switch# config terminal
switch(config)# fcsp enable
switch(config)# fcsp timeout 60
Related Commands
timeout-period Specifies the time out period. The time ranges from 20 to 100 seconds. The
default is 30 seconds.
Release Modification
1.3(1) This command was introduced.
Command Description
fcsp enable Enable FC-SP.
show fcsp Displays configured FC-SP information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English