Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-95
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
iscsi virtual-target name
iscsi virtual-target name
To create a static iSCSI virtual target, use the iscsi virtual-target command. To revert to the default
values, use the no form of the command.
iscsi virtual-target name name
advertise interface {gigabitethernet slot/port[.subinterface] | port-channel
channel-id[.subinterface]}
all-initiator-permit
initiator {initiator-name | ip-address ipaddress [netmask]} permit
pwwn pwwn-id [fc-lun number iscsi-lun number [secondary-pwwn pwwn-id [sec-lun
number]] | secondary-pwwn pwwn-id]
revert-primary-port
trespass
iscsi virtual-target name name
no advertise interface {gigabitethernet slot/port[.subinterface] | port-channel
channel-id[.subinterface]}
no all-initiator-permit
no initiator {initiator-name | ip-address ipaddress [netmask]} permit
no pwwn pwwn-id [fc-lun number iscsi-lun number [secondary-pwwn pwwn-id [sec-lun
number]] | secondary-pwwn pwwn-id]
no revert-primary-port
no trespass
no iscsi virtual-target name name
Syntax Description name Enters the virtual target name to be used. The minimum length is 16
characters and maximum of 223 bytes.
advertise interface Advertises the virtual target name on the specified interface.
gigabitethernet slot/port
[.subinterface]
Selects the Gigabit Ethernet interface or subinterface to configure.
port-channel channel-id
[.subinterface]
Selects the Port Channel interface or subinterface to configure.
all-initiator-permit Enables all iSCSI initiator access to this target.
initiator Configures specific iSCSI initiator access to this target.
initiator-name Specifies the iSCSI initiator name to be used access a specified target.
Maximum length is 255 characters.
ip-address ip-address Specifies the iSCSI initiator IP address.
ip-subnet Specifies all initiators in the subnet.
permit Permits access to the specified target.
pwwn pwwn-id Specifies the peer WWN ID for special frames.
secondary-pwwn pwwn-id Specifies the secondary pWWN ID.
fc-lun number Specifies the Fibre Channel Logical Unit Number (LUN).
iscsi-lun number Specifies the iSCSI virtual target number.
sec-lun number Specifies the secondary Fibre Channel LUN.
trespass Moves LUNs forcefully from one port to another.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English