Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-55
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ips netsim delay-ms
ips netsim delay-ms
To delay packets that arrive at a specified Gigabit Ethernet interface specifying milliseconds, use the ips
netsim delay command in SAN extension tuner configuration submode.
ips netsim delay-ms milliseconds ingress gigabitethernet slot/port
Syntax Description
Defaults Disabled.
Command Modes SAN extension tuner configuration submode.
Command History
Usage Guidelines To use this command, you must enable the IP Network Simulator using the ips netsim enable command.
This command introduces a delay for all packets entering the Gigabit Ethernet interface. Delay is
unidirectional. To introduce delay in the opposite direction, use the slot and port number of the adjacent
interface.
Examples The following example shows how to configure a delay of 50 milliseconds for packets entering Gigabit
Ethernet interface 2/3.
switch# config terminal
switch(config)#
switch(config)# san-ext-tuner enable
switch(config)# exit
switch#
switch# ips netsim delay-ms 50 ingress gigabitethernet 2/3
Related Commands
delay-ms milliseconds Specifies the delay in milliseconds. The range is 0 to 150.
ingress Specifies the ingress direction.
gigabitethernet
slot/port
Specifies the the slot and port number of the Gigabit Ethernet interface.
Release Modification
3.1(1) This command was introduced.
Command Description
show ips netsim Displays a summary of the interfaces that are currently operating in network
simulation mode.
ips netsim enable Enables the IP Network Simulator.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English