Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-60
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug idehsd
debug idehsd
To enable IDE hot swap handler debugging, use the debug idehsd command in EXEC mode. To disable
a debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
debug idehsd {cmd dbglevel [debug-level] | error | flow}
no debug idehsd {cmd dbglevel [debug-level] | error | flow}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug idehsd cmd dbglevel command is
issued:
switch# debug idehsd cmd dbglevel 5
set debug level to 5 succeeded
Related Commands
cmd dbglevel Enables debugging for the IDE hot swap handler.
debug-level Specifies the debug level (0 to 8).
error Enables debugging for IDE hot swap handler error conditions.
flow Enables debugging for IDE hot swap handler flow.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English