Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-112
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug snmp
debug snmp
To enable debugging for the SNMP manager, use the debug snmp command in EXEC mode. To disable
a debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
debug snmp {
all |
errors |
mts {pkt {both | rx [node range | opcode range | sap range] | tx} |
pkthdr {both | rx [numpkt range] | tx}} |
pkt-dump | trace {trace-entryexit | trace-stub}}
no debug snmp {
all |
errors |
mts {pkt {both | rx [node range | opcode range | sap range] | tx} |
pkthdr {both | rx [numpkt range] | tx}}
|
pkt-dump | trace {trace-entryexit | trace-stub}}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
all Enables debugging for all SNMP output.
errors Enables debugging for SNMP error output.
mts Enables debugging for SNMP packets and headers.
pkt-dump Enables a packet dump of debug output.
trace Enables trace level debug output.
pkt Specifies debugging of packets.
pkthdr Specifies debugging of headers.
both Specifies debugging in both the transmit and receive directions.
tx Specifies debugging in the transmit direction.
rx Specifies debugging in the receive direction.
node Specifies the node for the packets in the receive direction.
opcode Specifies the opcode for the packets in the receive direction.
sap Specifies the sap for the packets in the receive direction.
numpkt Specifies the number of required packets
range Specifies the integer range from 1 to 4095.
trace-entryexit Specifies trace-level entry or exit debug output.
trace-stub Specifies trace-level stub debug output.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English