Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-67
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ipv6 access-list
ipv6 access-list
To configure an IPv6 access control list (ACL) and enter IPv6-ACL configuration submode, use the ipv6
access-list command in configuration mode. To discard an IPv6 ACL, use the no form of the command.
ipv6 access-list list-name
no ipv6 access-list list-name
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines Before using the ipv6 access-list command to configure an IPv6 ACL on a switch, become familiar with
the features of IPv6 and its extended addressing capabilities. In particular, it is important to understand
the different types of IPv6 address formats, the IPv6 address prefix format, and the different IPv6 address
types. For detailed information about IPv6, refer to the Cisco MDS 9000 Family CLI Configuration
Guide.
Examples The following example configures an IPv6 access list called List1 and enters IPv6-ACL configuration
submode.
switch # config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# ipv6 access-list List1
switch(config-ipv6-acl)#
The following example removes the IPv6 access list called List1 and all of its entries.
switch(config)# no ipv6 access-list List1
switch(config)#
Related Commands
list-name Specifies an IP access control list name. The maximum size is 64.
Release Modification
3.0(1) This command was introduced.
ipv6 route Configures an IPv6 static route.
ipv6 routing Enables IPv6 unicast routing.
show ipv6 access-list Displays a summary of ACLs.
show ipv6 route Displays the IPv6 static routes configured on the switch.
show ipv6 routing Displays the IPv6 unicast routing configured on the switch.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English