Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
8-43
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fcs virtual-device-add
fcs virtual-device-add
To include a virtual device in a query about zone information from an FCS, use the fcs
virtual-device-add command in configuration mode. To remove a virtual device, use the no form of the
command.
fcs virtual-device-add [vsan-ranges vsan-ids]
no fcs virtual-device-add [vsan-ranges vsan-ids]
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines VSAN ranges are entered as vsan-ids-vsan-ids. When you specify more than one range, separate each
range with a comma. If no range is specified, the command applies to all VSANs.
Examples The following example shows how to add to one range of VSANs.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fcs virtual-device-add vsan-ranges 2-4
The following example shows how to add to more than one range of VSANs.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fcs virtual-device-add vsan-ranges 2-4,5-8
Related Commands
vsan-ranges vsan-ids Specifies one or multiple ranges of VSANs. The range is 1 to 4093.
Release Modification
3.1(2) This command was introduced.
Command Description
show fcs Displays fabric configuration server information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English