Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
25-2
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 25 V Commands
virtual-domain (SDV virtual device configuration submode)
virtual-domain (SDV virtual device configuration submode)
To configure a persistent virtual domain, use the virtual-domain command in SDV virtual device
configuration submode. To remove a persistent virtual domain, use the no form of the command.
virtual-domain domain-name
no virtual-domain domain-name
Syntax Description
Defaults No virtual domains are configured by default.
Command Modes SDV virtual device configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows how to configure a persistent virtual domain.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# sdv virtual-device name sqa1 vsan 1
switch(config-sdv-virt-dev)# virtual-domain 1
Related Commands
domain-name Specifies the persistent virtual domain. The range is 1 to 239 or 0x1 to 0xef.
Release Modification
3.1(2) This command was introduced.
Command Description
sdv enable Enables or disables SAN device virtualization.
show sdv statistics Displays SAN device virtualization statistics.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English