Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
27-6
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zone copy
zone copy
To copy the active zone set to the full zone set, use the zone copy command in EXEC mode. Use the no
form of the command to negate the command or revert to the factory defaults.
zone copy active -zoneset full-zoneset vsan vsan-id
zone copy vsan vsan-id active-zoneset {bootflash: ftp: | full-zoneset | scp: | sftp: | tftp: |
volatile:}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example copies the active zone set to the full zone set.
switch# zone copy active-zoneset full-zoneset vsan 1
The following example copies the active zone set in VSAN 3 to a remote location using SCP.
switch# zone copy vsan 3 active-zoneset scp://guest@myserver/tmp/active_zoneset.txt
active-zoneset Copies from the active zone set.
vsan vsan-id Configures to copy active zone set on a VSAN to full zone set.The ID of the
VSAN is from 1 to 4093.
full-zoneset Copies the active-zone set to the full-zone set.
bootflash: Copies the active-zone set to a location in the bootflash: directory.
ftp: Copies the active-zone set to a remote location using the FTP protocol.
scp: Copies the active-zone set to a remote location using the SCP protocol.
sftp: Copies the active-zone set to a remote location using the SFTP protocol.
slot0: Copies the active-zone set to a location in the slot0: directory.
tftp: Copies the active-zone set to a remote location using the TFTP protocol.
volatile: Copies the active-zone set to a location in the volatile: directory.
Release Modification
1.3(1) This command was modified.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English