Send documentation comments to mdsfeedback-doc@cisco.com
21-37
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
snmp-server host
snmp-server host
To specify the recipient of an SNMP notification, use the snmp-server host global configuration command. To
remove the specified host, use the no form of the command.
snmp-server host host-address [traps | informs] [version {1 | 2c | 3 [auth | noauth | priv]}]
community-string [udp-port port]
no snmp-server host host-address [traps | informs] [version {1 | 2c | 3 [auth | noauth | priv]}]
community-string [udp-port port]
Syntax Description
Defaults Sends SNMP traps.
Command Modes Configuration mode.
Command History
Usage Guidelines If you use the version keyword, one of the following must be specified: 1, 2c, or 3.
Examples The following example specify the recipient of an SNMP notification.
switch# config terminal
switch(config)# snmp-server host 10.1.1.1 traps version 2c abcddsfsf udp-port 500
host-address Specifies the name or IP address of the host (the targeted recipient).
traps Sends SNMP traps to this host.
informs Sends SNMP informs to this host.
version Specifies the version of the Simple Network Management Protocol (SNMP)
used to send the traps. Version 3 is the most secure model, as it allows packet
encryption with the priv keyword.
1 SNMPv1 (default). This option is not available with informs.
2c SNMPv2C.
3 SNMPv3 has three optional keywords (auth, no auth (default), or priv).
auth Enables Message Digest 5 (MD5) and Secure Hash Algorithm (SHA) packet
authentication
noauth Specifies the noAuthNoPriv security level.
priv Enables Data Encryption Standard (DES) packet encryption (privacy).
community-string Sends a password-like community string with the notification operation.
udp-port Specifies the port UDP port of the host to use. The default is 162.
Release Modification
1.0(3) This command was introduced.
To Next Page
Loading...
Need help?
General