Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-18
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show cdp
show cdp
To display CDP parameters configured globally or for a specific interface, use the show cdp command.
show cdp {all | entry [all | name cdp-name] | global | interface [gigabitethernet slot/port |
mgmt 0] | neighbors [detail | interface {gigabitethernet slot/port | mgmt 0}] | traffic
interface [gigabitethernet slot/port | mgmt 0]}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines This command is allowed only on the active supervisor module in the Cisco MDS 9500 Series.
all Displays all enabled CDP interfaces.
entry Displays CDP database entries.
all Displays all CDP entries in the database
name cdp-name Displays CDP entries that match a specified name. Maximum length is 256
characters.
global Displays global CDP parameters.
gigabitethernet
slot/port
Specifies the Gigabit Ethernet interface at the slot number and port number
separated by a slash (/).
mgmt 0 Specifies the Ethernet management interface.
neighbors Displays all CDP neighbors.
detail Displays detailed information for all CDP neighbors
interface Displays CDP information for neighbors on a specified interface.
traffic Displays CDP traffic statistics for an interface.
Release Modification
1.1(1) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English