Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-9
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
scsi-flow flow-id
scsi-flow flow-id
To configure SCSI flow services, use the scsi-flow flow-id command. To disable the SCSI flow services,
use the no form of the command.
scsi-flow flow-id flow-id {initiator-vsan vsan-id initiator-pwwn wwn target-vsan vsan-id
target-pwwn wwn |
statistics |
write-acceleration [buffers count]}
no scsi-flow flow-id flow-id [statistics | write-acceleration]
Syntax Description
Defaults SCSI flow services are disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines You must enable the SCSI flow feature on the Storage Services Module (SSM) before you can configure
a SCSI flow. Use the ssm enable feature module slot-number command to enable the SCSI flow feature
on the SSM.
flow-id Configures the SCSI flow identification number. The range is 1 to 65535.
initiator-vsan vsan-id Specifies the initiator VSAN identification number. The range is 1 to 4093.
initiator-pwwn wwn Configures initiator side PWWN.
target-vsan vsan-id Configures target VSAN identification number of the SCSI flow.
target-pwwn wwn Configures the target side PWWN.
write-acceleration Enables write acceleration.
statistics Enables statistics gathering.
buffers count Configures the write acceleration buffer count. The range is 1 to 40000 and
the default is 1024.
Release Modification
2.0(2) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English