Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
2-16
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 2 A Commands
attach
attach
To connect to a specific module, use the attach command in EXEC mode.
attach module slot-number
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines You can use the attach module command to view the standby supervisor module information, but you
cannot configure the standby supervisor module using this command.
You can also use the attach module command on the switching module portion of the Cisco MDS 9216
supervisor module, which resides in slot 1 of this two-slot switch.
To disconnect, use the exit command at the
module-number# prompt, or type $. to forcibly abort the
attach session.
Examples The following example connects to the module in slot 2. Note that after you connect to the image on the
module using the attach module command, the prompt changes to module-number#.
switch# attach module 1
Attaching to module 1 ...
To exit type 'exit', to abort type '$.'
module-1# exit
switch#
Related Commands
module slot-number Specifies the slot number of the module.
Release Modification
1.0(2) This command was introduced.
Command Description
exit Disconnects from the module.
show module Displays the status of a module.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English