Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-106
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
system watchdog
system watchdog
To enable watchdog checks, use the system watchdog command in EXEC mode. To disable this feature,
use the no form of the command.
system watchdog
system no watchdog
Syntax Description This command has no arguments or keywords.
Defaults Enabled.
Command Modes EXEC mode.
Command History
Usage Guidelines If a watchdog is not logged at every 8 seconds by the software, the supervisor module reboots the switch.
You can disable the watchdog checking feature (enabled by default) for debugging and troubleshooting
purposes like attaching a GDB or a kernel GDB (KGDB) to a specified process.
Examples The following example enables the system watchdog.
switch# system watchdog
Release Modification
1.0(2) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English