Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-30
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
interface gigabitethernet
interface gigabitethernet
To configure an Gigabit Ethernet interface, use the interface gigabitethernet command. To revert to the
default values, use the no form of the command.
interface gigabitethernet slot/port
cdp enable
channel-group group-id [force]
isns profile-name
interface gigabitethernet slot/port
no cdp enable
no channel-group
no isns profile-name
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines You can specify a range of interfaces by issuing a command with the following example format:
interface gigabitethernet1/1space-space2space,spacegigabitethernet3/1space-space2
Examples The following example configures the Gigabit Ethernet interface at slot 4 port 1.
switch# config terminal
switch(config)# interface gigabitethernet 4/1
switch(config-if)#
slot/port Specifies a slot number and port number.
cdp enable Enables Cisco Discovery Protocol (CDP) configuration parameters.
channel-group group-id Adds to or removes from a PortChannel. The range is 1 to 128.
force Forcefully adds a port.
isns profile-name Specifies the profile name to tag the interface. Maximum length is 64
characters.
Release Modification
1.0(3a) This command was introduced.
1.1(1a) Added the channel-group subcommand.
1.3(1) Added the isns subcommand.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English