Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
19-3
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 19 Q Commands
qos control priority
qos control priority
To enable the QoS priority assignment for control traffic feature on the Cisco MDS 9000 family of
switches, use the qos control command in configuration mode. To revert to the factory default, use the
no form of the command.
qos control priority 0
no qos priority control 0
Syntax Description
Defaults Enabled and priority 7 are the defaults.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example sets the QoS priority assignment to the highest level.
switch# config terminal
switch(config)# no qos control priority 0
Related Commands
0 Specifies the lowest priority. To revert to the highest priority, use the no form
of the command.
Release Modification
1.0(2) This command was introduced.
Command Description
show qos Displays configured QoS information.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English