Example
CHANGE()
EXIT ; If any of the variable values change, the di-
alog will be terminated.
END_CHANGE
See also
Behavior when opening the dialog (attribute CB)
(Page 204)
6.2.3 CHANNEL
Description
The CHANNEL method is run through when the current channel has changed for an opened
screen, i.e. a channel switchover has been performed.
Programming
Syntax: CHANNEL
<instructions>
END_CHANNEL
Description: Channel switchover
Parameters: - None -
See also
S_CHAN variable
(Page 87)
6.2.4 CONTROL
Description
The CONTROL method is run through when the current control has changed for an opened
screen, i.e. typically at a 1:n switchover.
Programming commands
6.2 Methods
SINUMERIK Integrate Run MyScreens
98 Programming Manual, 10/2015, 6FC5397-3DP40-5BA3
To Next Page
Loading...
Need help?
General
