4.6.3 How to compare data
Compare data
You can select different data sources for the data comparison: Store the current data in files
on the controller or data.
Procedure:
1. Select the "Compare data" option.
2. In the data structure, select the data that you want to compare.
3. Press
the "Add to list" softkey to transfer the data to the list in the lower area of the display.
4. Press the "Delete from list" softkey to remove the data again.
5. If the list contains more than two data objects, you can activate the checkbox to compare
two or more data objects from the list.
6. Press the "Compare" softkey to start the comparison. The display of the comparison results
can take some time for extensive parameter lists.
7. Press the "Legend" softkey to display or hide the legend. The following display is the default:
– Different parameters are displayed.
– The same parameters are not displayed.
– Parameters not available everywhere are displayed.
Parameterizing machine data
4.6 Managing data
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 91
To Next Page
Loading...
Need help?
General
