Siemens SINUMERIK 828D Commissioning Manual

6.3.6 Copy Program file function (CP)
Description
The CP (Copy Program) function copies files within the HMI file system or within the NC file
system.
Programming
Syntax: CP
("Source file", "Target file")
Description: Copies a file
Parameter: Source file Complete path to the source file
Target file Complete path data of the target file
The return value (VAR1 defined as help variable) queries whether the function was successful:
CP("//NC/MPF.DIR/HOHO.MPF","//NC/MPF.DIR/ASLAN.MPF",VAR1)
Example
Application with return value:
CP("//NC/MPF.DIR/HOHO.MPF","//NC/MPF.DIR/ASLAN.MPF",VAR1)
CP("CF_CARD:/wks.dir/MESS_BILD.WPD/MESS_BILD.MPF","//NC/WKS.DIR/AAA.WPD/HOHO2.MPF",VAR1)
CP("//NC/MPF.DIR/HOHO.MPF","//NC/MPF.DIR/ASLAN.MPF") ; WPD must exist
Application without return value:
CP("//NC/MPF.DIR/HOHO.MPF","//NC/MPF.DIR/ASLAN.MPF")
CP("CF_CARD:/mpf.dir/MYPROG.MPF","//NC/MPF.DIR/HOHO.MPF")
CP("//NC/MPF.DIR/HOHO.MPF","CF_CARD:/XYZ/MYPROG.MPF") ; XYZ must exist
See also
Support of FILE_ERR: FILE_ERR variable
(Page 84)
6.3.7 Delete Program file function (DP)
Description
The DP (Delete Program) function deletes a file from the passive HMI or active NC file system.
Programming commands
6.3 Functions
SINUMERIK Integrate Run MyScreens
114 Programming Manual, 10/2015, 6FC5397-3DP40-5BA3

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English