Marker Action
_M231 Start of program (ShopMill program)
_M232 End of program header (ShopMill program)
_M235 End of program loop (ShopMill program)
_M236 End of program (ShopMill program)
_M300 Boring CYCLE86
Adapt the spindle to the tool position (SD55216 $SCS_FUNCTION_MASK_DRILL_SET
bit 6 = 1)
7.3.5 CUST_MULTICHAN user cycle
Function
The CUST_MULTICHAN cycle is
used for multi-channel programming at lathes. It is called at
the start of the block when programming with blocks.
In the cycle, e.g. the master spindle is set to the spindle specified at the start of the block. The
return value (= 1) can be used to control whether the complete block is skipped.
CUST_MULTICHAN
Parameter Meaning
_S_NR Spindle number to which the master spindle is set.
_RET
= 0
= 1
Return value
The block is executed corresponding to the run-in mode.
The entire block is skipped.
7.3.6 Commissioning multi-channel machines with programSYNC
This section describes the special features that you must observe during the commissioning
of a multi-channel machine with programSYNC (option) and ShopTurn.
Software option
You
require
the
following
software option in order to use the programSYNC function:
"programSYNC".
Configuring cycles
7.3 Manufacturer cycles
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 87
To Next Page
Loading...
Need help?
General
